Pocket Door Handle Installation

Use your pencil to mark the jamb of the door for the latch plate to be installed.

Pocket door handle installation.

To use the locking lever turn the lever which is on the lock body at the side. Install the header and track assembly on the top jamb with the fasteners and brackets supplied with the door. Be sure to screw the brackets into the studs. Position the pocket door pull on the edge of the door backwards and mark the center using a carpenter s pencil.

See more ideas about pocket door hardware pocket doors door hardware. Place a mark where this lever comes into contact with door jamb. Step 4 drill holes. Measure up 36 inches from the floor.

Check that the track is level so that the door rolls easily. The pocket door is to be closed almost all the way. Follow the manufacturer s instructions and cut the pocket door header and track assembly to length with a hacksaw. Step 1 read the directions.

How to install your pocket door hardware in 5 steps. Wherever you purchased your pocket door hardware start by reading the directions that come with the door hardware that you purchased make sure that the hardware is for the thickness and the type of door that you are installing the hardware for and take note of any warnings or special notes the manufacturer gives. Then put the hardware and door into the slider track. Nail the end plate to the wall studs.

You can install the door pull on any pocket door that s been previously installed. Step 2 position pocket door pull. Next install the slider track using the rails that came in your pocket door kit. Step 3 mark the screw points.

Jun 23 2020 explore hartford bldg prod s board pocket door hardware on pinterest. 1 pull the door halfway open by grasping the edge of it with your fingertips. To install a pocket door start by removing the existing door and the drywall on one side of the wall. Trace the lever outline on the door s edge.

Then cut the exposed studs to make room for the new framing. Mark the spots for the mounting screws using an awl. The latch plate hole needs to be in the center of the pencil mark.