The layer thickness ranges from 300mm to 500mm and the time between successive layers should not exceed 30 minutes for normal weather condition and 20 minutes for hot weather condition.
Pouring a concrete wall in sections.
Create contraction joints every 4 6 feet.
Allow concrete to cure.
Pour footings and wall.
Pouring of concrete in columns and walls if the height of these elements is large then it is recommended to place concrete in layers.
Follow the instructions on the bag of cement and mix accordingly.
If the wall exceeds four feet in height footings should be poured separately.
Roll the wheelbarrow of cement over to your wooden forms and pour the cement into the footing and form area.
In this situation people often go for u cart type concrete where you go to a provider who rents you a trailer with a yard of mixed and ready to pour concrete in it.
Pour the retaining wall.
Pouring concrete in sections can also extend the life of your poured surfaces as the weight from a huge slab is not weighing in on the center of the piece like on huge slabs.
See below for more information on contraction joints remove forms and install waterproofing and drainage system.
Once you have mixed the cement in the cement mixer dump it into the wheelbarrow.
Once the truck has reached the end of a section spread the concrete out evenly and a touch higher than the form with a concrete placer rake.
Ready mix concrete trucks the big concrete trucks that deliver concrete and spin usually have a three yard minimum order.
Finish the surface of the wall as desired.