Here is how to fix it.
Reset sliding door on pontiac van.
Press the open button on the remote key fob to open the sliding doors.
If the door reverses and or stops prior to completing the two cycles the procedure will need to be repeated.
Open and close the power sliding doors twice with the overhead or b pillar switch to relearn the position.
A common problem on uplanders is the sliding door roller fails.
Open the sliding door and locate the bearing near the bottom.
When i turn off the car and take the keys out of the ignition there is a loud irritating noise from the right sliding door on the passenger side.
If the power sliding door or power tailgate doesn t work properly after above procedure have the system checked by an authorized kia dealer.
Close the sliding door completely using the transmitter or main control button on the overhead console.
The door will have to be relearned.
For the left right power sliding doors and power tailgate follow above steps to reset.
Wait 10 seconds then open the door with the remote again.
Do not grease the rollers as the grease will pick up all foreign matter and will cause more problems with the door.
Any time i press the key fob you can still hear this sound from the sliding door.
The procedure shown here is on a 2006 toyota sienna but the ideas and techniques should apply to most van sliding doors.
Once the third cycle completes the power door battery is reset.
Sliding door on 2001 pontiac montana.
Open the door as far as it will go.
Any help recommendaitons would be greatly appreciated.
Close the door and wait 10 seconds.
The power sliding door fuse will have to be removed for 1 min.
While looking at the lower track where the door assembly rolls start to close the door about 2 inches or so.
The first step is to get a hold of some silicone spray like this stuff for example.
Push this down easily done with just your finger.
Turn the ignition on.
Move the power sliding door switch to off then move it back to on this switch is located to the left of the steering wheel.
Make sure the power sliding door overhead switch is off.
You will see the pop up raised just behind the large carrier arm.