Remove the battery pack.
Rogers door lock battery replacement.
Make sure the batteries are working by pressing the lock button on the door lock s keypad.
Find locking mechanism tab on the narrow side of sensor with led light pointing toward it.
Remove the battery pack from the interior assembly.
Yes i understand that but for rogers to replace the batteries they need to send it into the repair facility so they can change the batteries for you.
Test the lock and unlock functionality of the door lock s keypad.
4 smart home monitoring battery replacement instructions 1.
Press locking mechanism using a flathead screwdriver until sensor pops off its base.
Tap on the door lock icon to be unpaired.
Use the ball tip of an allen wrench to remove the three screws holding the cover.
Remove the battery cover.
If the batteries are fine the keypad will light up.
Smart door lock weiser smartcode 10 touchpad electronic deadbolt 2.
Manufacturer s installation guide important installation steps 1.
Hold the program button for 30 seconds until the status led flashes red.
The led blinks green 7.
Replace the sensor back plate as shown on the left.
Remove and replace battery.
The stores have no way and are not allowed to change the batteries for you as they only have batteries to sell not to give out for warranty issues.
Pair the smart door lock to your rogers smart home monitoring system using.
Remove the existing door lock.
Confirm door lock delete screen will appear.
After 1 second release the tamper switch.
This is the only way to get a battery from them.
Install the smart door lock using the manufacturer s installation guide provided in the box.
Press and hold the program button while reinserting the battery pack.
While pressing and holding the tamper switch insert the battery into the sensor with the positive end oriented towards the tamper switch.
If the keypad doesn t light up open the battery pack and replace the batteries with fresh alkaline ones.
Remove the battery cover using the allen key.
The front panel led comes on 6.
Select yes to un pair.
4 smart home monitoring battery replacement instructions 1.
Press the program button again.
Install 4 aa batteries in battery pack.
An allen wrench is provided in the original door lock box 2.